Automotive

High-Volume Air Filter Housing Production

High-Volume Air Filter Housing Production

The challenge

Makers of air filter, oil filter and fluid housings need thousands of identical round bodies, with a consistent diameter and a clean seam. The sheet is often coated or pre-finished, so scratches and marks from the forming process are not acceptable.

  • High volume production with very little variation from piece to piece
  • Small and medium diameters formed without special tooling
  • Surface of the sheet must stay clean
  • Manpower and handling time must be kept low

Our solution

A Two Roll Sheet Rolling Machine forms each sheet in a single controlled pass. A hardened upper roll (up to 52-55 RC) works against a polyurethane lower roll, so the sheet is supported gently and the surface stays clean.

Machine used

Two Roll Sheet Rolling Machine, Model 2R----

Key specifications
  • Sheet width up to 2000 mm
  • Sheet thickness up to 5 mm
  • Rolling diameter as small as 25 mm
  • Hardened rolls up to 52-55 RC
  • Heavy duty roller bearings and a frame built from tested steel plate
  • Control desk conveniently located on the machine

Project results

  • Production capability up to 3 pieces per minute
  • Repeatable diameter and seam gap, piece after piece
  • Gentle handling that protects coated and finished sheet
  • All operations can be fully automated, with automatic loading and unloading for a continuous line
Back to all projects